By Jenni Wirtz | 24 September, 2018


After the long dry summer, autumn is the season when the 1000’s of iconic classic vehicles that are still driven by their enthusiastic owners will be receiving some well-earned maintenance before being laid-up for the winter.

Although some of the work will be undertaken by competent owners, others will use an independent workshop, which when presented with a classic, should respect the originality of the vehicle and fit brands that were used in the vehicle’s original manufacture. When it comes to the clutch, 85% of all British-built cars were fitted with Borg & Beck, so for the replacement items original Borg & Beck really is the best option.

Although similar in operation to current clutches, when the clutch itself needs replacement, many will not have worked with these early designs. However, the company’s in-house Classic Clutch engineer provides the following advice when carrying out replacement of an ‘A’ or ‘AS’ type Borg & Beck clutch.

The ‘A’ and ‘A2’ types are usually of a single dry plate design comprising a cover assembly, driven plate assembly and release bearing, which utilises a pressure plate that is driven by the pressed steel cover via machined pressure plate lugs engaging into slots.

In the original Borg & Beck clutch service manuals it was advised to carry out a full inspection of the clutch system as part of the vehicle’s maintenance schedule as outlined here.

Removal of the clutch assembly from the vehicle

Loosen each of the bolts securing the clutch to the flywheel, but to avoid distorting the cover flange, slacken them a turn at a time, diagonally, until the pressure of the clutch springs is relieved. Then undo the bolts and the complete clutch, including the driven plate can be carefully removed.

Inspect the flywheel – scoring may occur on the face of the flywheel in which case it must be re-ground or replaced as even slight scoring will cause excessive wear of the clutch facings.

The complete dismantling of the clutch was also advised in the original service schedule, however this is not advised today. It is more viable to replace the whole unit rather than dismantle the ‘A’ and ‘A2’ type assemblies to service the individual components, as this can be both time consuming and dangerous if a technician has not opened one up before, as it is fully loaded with springs.

When fitting the clutch back onto the vehicle the principles employed in the past still resonate today – use a driven plate alignment shaft – as misalignment is responsible for almost every case of rapid spline wear, broken drive plates, damaged transmission bearings and gears.

As always, ensure the gearbox is adequately supported and not permitted to hang on the clutch, as serious damage may result. When guiding the gearbox into the assembly position, get the first motion shaft in true alignment with the driven plate hub and turn the main output shaft each way slightly – with gearbox in gear – to ensure smooth engagement of the splined parts. A light smear of grease should be placed on the shaft prior to installation of the gearbox.

Once installed check the clutch pedal adjustment – in accordance with the vehicle manufacturers instructions.

Borg & Beck’s Classic Clutch range provides the solution for more than 200 classic applications, including such icons as the Aston Martin DB4, Jaguar E Type, Morris Minor and Triumph TR range, therefore when it comes to Clutch, only fit original Borg & Beck.


FOR THE LATEST NEWS & UPDATES

SUBSCRIBE

X

WEBCAT - ONLINE CATALOGUE

WARRANTY PORTAL

CV SEARCH

MARKETING HUB

FIRST LINE LTD